Sign Up Below to Get Your Beta Access Key:
Installation
Location
Connection
Water
Power
Location
- The pump should be installed in an outside area with good air flows
- Both the air inlet and outlet must be unobstructed with 2m clear space in front of the unit
- A drain must be provided to allows condensate to disperse without flooding
- Mount on a smooth, solid base designed to support the weight of the unit, fixed with bolts and using anti-vibration pads
- The unit must be mounted vertically
- The unit should not be near sources of pollution, corrosion or dead leaves
- Do not place near other heat sources
Connection
- The drain and overflow pipes should be installed over a suitable drain
- When using plastic piping, expansion and contraction should be considered between the heat pump and the hot water tank
- Insulation should be used on all pipework to prevent frost damage and heat loss
Water
- Bends in pipework should be minimised to reduce frictional energy losses
- All pipes should be checked for leaks during installation and in periodic maintenance
- On completion of installation, the pipework should be pressure tested, vented and filled with clean water dosed with approved inhibitor
Power
- Prior to installation check requirement for single or three phase power and confirm availability on site
- The connecting supply must be isolated and secured in the off position prior to installation
- Grommets must be used where cables enter electrical boxes
- Power supply:
- 220V +/- 10% 1 Ph
- 380V +/- 10% 3 Ph
- 50Hz +/- 2%
“
The performance figures for Aquarius are truly impressive, the build quality is reassuringly high, and the price is unbeatable.
Carl Benfield, Director